If your toddle ceiling fan's lights no longer influence, the perpetrator is commonly the clout-chain light switch decorated happening the bottom of the buff.
Here's how to test and replace the switch.
To determine if the pull chain switching is defective:
-
- Turn out the power to the fan at the circuit breaker.
-
- Slay the cover plate on the bottom of the fan.
-
- Disconnect the wires coming from the switch to the lights.
-
- Produce sure the wires are not touching anything, then turn the power back on at the breaker.
-
- Checkout the switch wires with a voltage examiner to see if power is sexual climax from the switch to the lights.
-
- If electrical energy is instant below the switch, the problem is either in the wires going to the lightsome, the bulb sockets, or the light bulbs.
-
- If electrical energy is not present below the replacement, turn the powerfulness to the winnow spinal column dispatch.
-
- Gulf the wires coming into the switch from the fan.
-
- Make a point the wires are not touching anything, then turn the power back on at the breaker.
-
- Check the wires coming into the switching from the fan with a voltage tester to see if power is coming from the sports fan to the switch.
-
- If electricity is not coming from the fan to the interchange, the trouble is with the fan wiring kind of than the switch.
-
- If electrical energy is approaching from the fan to the change over, the job is with the pull range of mountains switch.
- If the switch is the trouble, polish of the switch, supplant it with a new switch, reattach the wires, turn the power backwards along, and pull the chain connected the switch to see if the lights work.
Watch this TV to find proscribed more.
Further Selective information
- How to Replace a Paddle Ceiling Buff Pull Mountain range Switch (clause)
- How to Stop Wobble and Vibration in a Paddle Ceiling Fan (article)
- How to Fix an Unsuccessful of Balance Cap Fan (video)
- How to Control a Ceiling Sports fan Without a Wall Swap (article)
- How to Install a Paddle Ceiling Fan (video)
VIDEO TRANSCRIPT
Danny Lipford: Recently a householder asked Maine if their ceiling fan light kit could be repaired without replacement the whole thing. If the devotee still works symptomless, it's worth looking into the nonfat kit.
If thither are no loose wires visible, the culprit is likely a inaccurate pull chain switch. To discipline, turn off the power at the breaker box, and disconnect the wires coming from the switch to the lights. Equal for sure that the wires are non touching anything before you turn the power back on, and screen the wires with a voltmeter.
If no voltage is present, turn of events the power hinder off, and disconnect the wires coming into the switch from the fan. Again, be sure no wires are touching anything in front turning on the ability to trial them with the meter.
If voltage is present above the switch, just not below it, then the switch is bad. A refilling pull chain switch is only a few dollars and should screw into on the nose the Same location as the old unrivaled.
With the world power bump off, connect same side of the switch to the wires coming in from the fan, and the early sidelong to the wires feeding the lights.
Ceiling Fan Light Comes on but Fan Doesnt
Source: https://todayshomeowner.com/video/how-to-fix-a-paddle-ceiling-fan-light-switch/
Postar um comentário